HVAC Licensing Exam Study Guide in .NET

Create QR in .NET HVAC Licensing Exam Study Guide

The ceiling is the most satisfactory location for radiant-heating panels A combination grid and continuous coil are used in a large installation where the heat requirements make it necessary to install several coils Ceiling panels should not be installed above plywood, composition board, or other insulating types of ceiling material Surfaces of this type have an undesirable insulating effect that diminishes full heat output of the panel Radiant panels are often installed in floors When this is done, the best arrangement is to place the coils in the concrete floor slab Good results are obtained when the pipe or tubing is placed at least 2 inches below the floor surface or deeper if a heavy traffic load is anticipated Allow a minimum of two weeks for the concrete to set before applying heat, and then apply heat gradually Floor covering of terrazzo, linoleum, tile, or carpeting can be installed If the water temperature is kept below the prescribed maximum of 85 degrees F, no damage will result to rugs, varnish, polish, or other materials A typical piping diagram for a radiant floor panel avoids low places in the coil Heat loss to the ground from a floor panel laid directly on the ground can be expected This loss is estimated to be from 10 to 20 percent of the heat provided for the room Heat loss from outside slab edges can be greater than this amount Slab edges should receive from l/2 inch to 2 inches of waterproof insulation It is not customary to install radiant wall panels except to provide supplementary heat where ceiling and/or floor panels do not provide a required degree of comfort Wall panels are occasionally installed in bathrooms where higher than normal heat temperatures may be desired In a typical radiant wall-panel installation diagram it must be remembered that circulating pumps for use with radiant heating should have a higher head rating than for convector systems of the same capacity This requirement exists because the coil pressure drop is considerably higher than the drop in a radiator or convector Certain fittings or devices are essential to the proper operation of a boiler The piping diagram is a typical steam boiler with the control and indicating devices that are essential to its proper operation One of the most important features is the safety valve Every boiler installation must have a safety valve installed to protect the boiler itself and the building occupants in case of malfunction These valves are adjusted to open and relieve the internal pressure should it rise above a safe predetermined level Numerous valves, gauges, and safety devices are found on all boilers The level of the water in a boiler must be maintained between certain limits; otherwise, serious damage to the boiler and building may result, as well as possible injury to the building occupants Various safety devices are incorporated to protect against this possibility Water gauges are provided as a means of visually checking the level More sophisticated gauges employ floats that actuate a whistle or other alarm when the water level drops to a dangerous point Pressure-relief valves and fusible plugs are also used to protect the boiler in case of malfunction Both of these devices will relieve dangerous high pressure under certain conditions Injectors are used to supply water against the high pressure existing within a boiler This is done by means of the jet principle Steam loops are often provided to return condensate to a boiler These devices are entirely automatic and have only one moving part, a check valve at the bottom of the drop leg Heating pumps are usually used in steam heating systems to improve efficiency Two principal types are available condensation pumps and vacuum pumps The type of heating system, cost, and individual requirements dictate which of these pumps must be used This heating section is a brief summary of steam and hot-water heating principles and in general contains the information necessary to answer questions pertaining to steam and hot-water heating that may be found in plumbing code examinations