Terminal Services and Remote Desktop in Software

Print Code 3/9 in Software Terminal Services and Remote Desktop

14 Click Close, and click Yes to restart your computer After restarting your roles, role services will be configured and you will be given a warning message that TS Licensing is not installed and that you have 119 days to do that (the day you install it counts as the first day) When it is done, you will be told it was successful Click Close NOTE The warning message that TS Licensing is not installed and that you have so many days to do that will reappear every time you restart your computer This is called nagware and it is unfortunate that Microsoft is using it 15 Open Roles in the left column of the Server Manager and click Terminal Services In the right pane, you should see three informational events that tell you that your TS RAP, TS CAP, and certificate have been created; the system services that are running; and the role services that are installed, as shown in Figure 11-3

TIP Since there s no obvious way to tell which of the three informational events is which, you can select each and click Properties to find out

NOTE Remote Desktop Connection, although not installed by default on Windows Server 2008, is automatically installed when you install TS See Use Applications Server Mode later in this chapter

11:

Once you have installed the TS role and the Terminal Server role service, you can configure TS using TS Configuration TS Configuration allows you to determine the TS connections that are on the computer and their properties, as well as the server settings There can be only one connection for each network interface card (NIC) or network adapter in the computer, and all connections use RDP with TCP/IP Therefore, if you have only one NIC or network adapter, the default connection is all that you need There are, though, some important settings in the connection s Properties dialog box Look at both the connection s settings and the server settings that are available in TS Configuration with these steps: 1 Open TS Configuration by clicking Start | Administrative Tools | Terminal Services | Terminal Services Configuration Or, in the Server Manager window, open Roles and Terminal Services, and click Terminal Services Configuration In either case, Terminal Services Configuration will open, either within the Server Manager, as you see in Figure 11-4, or within its own window

2 Add additional connections if you have more than one NIC or network adapter, by clicking Create New Connection in the Actions pane on the right The Terminal Services Connection Wizard will open Click Next, enter the connection name and comments, and click Next Select the network adapter to use and the number of connections Click Next, review your settings, and click Finish 3 To change the properties of an existing connection, right-click the connection, such as the default RDP-TCP connection, and click Properties The RDP-TCP Properties dialog box will open

4 Go through each of the tabs The settings you can change are as follows: General Add a comment to the connection s description and switch to High encryption Log On Settings Provide automatic logon by specifying the logon information to always use and whether a password will be requested Sessions Determine when to end a terminal session and how to reconnect if disconnected

Environment Specify which, if any, program should be started when the user logs on, and what folder it should point to

11:

Remote Control Determine whether to allow the remote control or observation of a user s terminal session and set the conditions under which it is allowed Client Settings Specify which of the client devices and capabilities will be available during a terminal session Network Adapter Specify the NIC or network adapter that will be used for this connection and the maximum number of connections to be allowed Security Determine the permissions to be allowed for a particular group or user and add groups and users as desired

5 When you have completed any changes you want to make, click OK to close the connection s Properties dialog box and return to Terminal Services Configuration 6 Click Server Settings The settings will appear on the right of the windows These settings are self-explanatory The settings are changed by right-clicking one of them, clicking Properties, and choosing the desired settings as shown next